Rig Noise

Ever since I replaced the standing rigging in Nuku Hiva and Tahiti I have been troubled by noises. I discovered that by lubricating the balls where the stays / shrouds attach to the mast they would twist off any twist I had inadvertently added by tightening the turnbuckles. But I still had a weird halyard slapping noise that sounded like a halyard hitting a shroud. Today my old eyes, the sun, the wind (and a little bit of rain) conspired to show me the problem. The port lazyjack lead is threaded incorrectly. This would be a minor problem if it wasn t 40 feet in the air and Reboot was not in a rolling anchorage. I am adding re-threading to the list of “things that require climbing the mast.” Hopefully I will find someone here in Sydney, Australia soon to tend my safety lines.Fair winds and following seas 🙂
http://feedproxy.google.com/~r/SailboatRacing-Rebootusa60493/~3/3nwBSYqJS-g/rig-noise.html

Quiet morning – tuning the rig


If you have been following my blog you know that I replaced all of Reboot s standing rigging in the past couple of months. I used swageless terminals (Hi-Mod) and discovered that after a few days of sailing they need to be re-tightened. At least the first couple of times while they set. For 7 of the cables this is not a problem. The fittings are out in the open, easy to see and tighten. But the last fitting is the headstay. The turnbuckle and fitting are under the furler. After a week of 20 knot winds we finally got a morning of calm. We took advantage of it to disassemble the furler, check the headstay (which was tight) and put it all back together. We then got out the Loos and static tuned the entire rig We should be ready for our planned departure for North Tonga (Vava u) tomorrow. Fair winds and following seas 🙂
http://feedproxy.google.com/~r/SailboatRacing-Rebootusa60493/~3/MEuFLj8a5Po/quiet-morning-tuning-rig.html

Working on the rig

Ever since we replaced the mid shrouds the rig has been making funny noises. We have been trying to figure out what is going on with little success. We did discover that the new fittings had worked loose and tightened them several times. Today we loosened each shroud so that we could lubricate the fittings. Much to our surprise as soon as we loosened the port mid it unwound about three revolutions while making the noise that has been driving me crazy. We let it settle after applying lubricant. When I tightened up the turnbuckle the noise was gone. I have no clue how the shroud got twisted. It is 19 strand wire. Half of the wires are laid clockwise and the other half counter clockwise. It is a mystery. Given the 20 knot winds in the anchorage we were unable to do a good static tune but we got close. I am hoping we have solved the problem. Fair winds and following seas 🙂
http://feedproxy.google.com/~r/SailboatRacing-Rebootusa60493/~3/Mtrv8Q8MYTk/working-on-rig.html